JNCIS-FWV Exam Objectives (Exam: JN0-532)
VPNs
Identify IKE Phase 1/Phase2 negotiation sequence and proposals
Identify/differentiate IPSec standard elements (encapsulations, SA, SPI, etc.)
List steps for policy-based/route-based VPN configuration
Relate proxy-ID to VPN setup
Identify proper configuration for various hub/spoke configurations (policy, int. placement, etc.)
Identify NHTB requirements/configurations
Configure/verify AC-VPNs
Identify PKI components (certificates, CDL, etc.)
List steps for PKI implementation w/ VPNs
VPN Variations
Configure Dynamic Peer VPNs
Configure Transparent mode VPNs
Configure Overlapping Networks
Describe GRE applications/Configure GRE
Network Management
Configure local management (SSL, SSH, management restrictions).
Interpret internal counters and logs.
Configure SYSLOG.
Discuss logging levels.
Configure SNMP.
Troubleshooting with Debug/Snoop
Enable debug/snoop.
Set debug filters.
Set snoop filters.
Use get commands to validates/troubleshoot routing and policies.
Use debug output to identify routing and policy problems.
Use get commands to validate/troubleshoot address translation.
Use debug output to identify problems.
Use get commands to validate/troubleshoot VPN setup.
Traffic Management
Describe the bandwidth allocation process.
Describe queuing functionality.
List requirements/steps for configuring traffic management.
Virtual Systems
Define VSYS applications
Describe root vs. VSYS administration
Explain VSYS vs. root assignment of routes/NAT pools/etc.
Configure interface-based VSYS
Configure inter-VSYS communications, including NAT.
Use show/debug output to identify VSYS usage.
Configure VSYS resource allocation
NSRP
Distinguish active/passive and active/active.
Describe NSRP operations (HA link, session sync, master election, etc.)
Configure active/passive and active/active NSRP.
Validate NSRP operations.
Adjust operations (secondary link, failover settings).
Configure redundant interface.
Dynamic Routing/Routing over VPNs
Configure RIP over VPNs
Configure OSPF over VPNs
Configure/verify OSPF routing
Configure OSPF options
Configure/verify BGP
Configure redistribution/filters/route maps
Configure static routes incl. floating static routes
Configure/verify source routing
Configure/verify policy routing
Attack Prevention
Describe SCREEN functions
Describe/configure Deep Inspection
Describe/configure anti-virus functionality
Configure web filtering
Multicast
Configure/verify IGMP
Configure/verify PIM-SM
QUESTION 1
You have created a VPN to a dynamic peer. Which two configured parameters must match?
(Choose two.)
A. static side peer-id
B. dynamic side local-id
C. static side IP address
D. dynamic side IP address
Answer: A,B
QUESTION 2
Which three events would cause ScreenOS devices to generate SNMP traps? (Choose three.)
A. cold starts
B. traffic alarms
C. warm reboots
D. self log events
E. traffic log events
Answer: A,B,C
QUESTION 3
Which command shows the filter applied to snoop captures?
A. get snoop
B. snoop info
C. get ffilter
D. get ffilter ip-proto snoop
Answer: B
Click here to view complete Q&A of JN0-532 exam
Certkingdom Review
Best Juniper JN0-532 Certification, Juniper JN0-532 Training at certkingdom.com